How to Change the Gears in a Side Wind Stand

If your side wind stand is becoming hard to wind, slipping, noisy, or damaged internally, replacing or servicing the gears can help restore smooth operation.

This guide walks through the process of disassembling the gearbox section of a side wind stand to access the internal gears and shaft components.

Tools Required

  • 1x Hammer
  • 1x Flathead Screwdriver
  • 1x 3mm Punch

Before You Start

Before disassembling the stand, ensure the foot and handle remain on the same side and in the same orientation during reassembly.

This will help ensure the stand operates correctly once rebuilt.

Step 1 – Remove the Plastic Caps

Undo the screw holding the two plastic caps in place on the gearbox housing.

Carefully remove the caps and retain the screw for reassembly.

Step 2 – Loosen the Caps

Using a hammer and flathead screwdriver, gently loosen the caps from the housing.

Take care not to damage the outer housing while prying the caps free.

Step 3 – Position the Stand

Flip the stand onto its side to provide easier access to the gearbox assembly and internal components.

Step 4 – Remove Grease and Locate the Roll Pin

Clean away some of the grease inside the gearbox so the internal shaft and roll pin are clearly visible.

Locate the roll pin that secures the shaft assembly.

Step 5 – Align the Keyway

Rotate and align the keyway with the outer sleeve to allow the shaft components to move freely during removal.

Correct alignment is important to prevent binding.

Step 6 – Remove the Keyway

Remove the keyway from the shaft.

Keep the keyway in a safe place for reassembly.

Step 7 – Remove the Side Wind Handle

Carefully remove the side wind handle from the gearbox assembly.

Step 8 – Remove the Gears

Slide and remove the internal gears from the shaft.

Inspect the gears for:

  • Wear
  • Chipped teeth
  • Rust or contamination
  • Excessive movement

Replace any damaged components as required.

Step 9 – Remove the Roll Pin

Using the 3mm punch and hammer, drive the roll pin from the shaft.

Take care not to damage the shaft during removal.

Step 10 – Remove the Leg from the Outer Sleeve

Once the roll pin has been removed, slide the leg from the outer sleeve.

The stand is now fully disassembled and ready for servicing, cleaning, or gear replacement.

Inspection Tips

While the stand is apart, inspect:

  • Gears
  • Shaft surfaces
  • Bushes
  • Grease condition
  • Handle movement
  • Internal wear points

Clean old grease thoroughly and apply fresh grease before reassembly.

Reassembly

Reassemble the stand in reverse order, ensuring:

  • The keyway is aligned correctly
  • The roll pin is fully seated
  • Components are adequately greased
  • The foot and handle remain in the original orientation

Test operation before reinstalling onto the trailer.

Need Replacement Parts?

Manutec offers a wide range of trailer stands, replacement components, and trailer hardware designed for Australian conditions.

👉 https://trailer.manutec.com.au/product-category/adjustable-stands-legs/adjustable-stands-spares/
📝 Contact Us
✉️ Email Us
📞 08 8260 2277